Volvo D2 Series Instrukcja Operatora Strona 24

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 76
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 23
22
Instrumentation
Set display contrast
Press button 5 (far right) to set display contrast. Then
press the appropriate buttons to adjust the levels and
save the settings by pressing EXIT. The display unit
has 5 contrast settings.
Configuration menu (button 5)
(depressed for longer than 3 s)
The configuration menu is used to:
- reach display mode SYSTEM INFORMATION
- make certain settings for the display
- calibrate depth offset and speed
- reach information and functions for
display service
Please refer to the configuration menu structure be-
low and read the following section, which explains
each section in the menu.
Important! Before the display can be used
with D1/D2 engines, engine series D1/D2 must
be selected in the configuration menu SET-
TINGS/ENGINE SERIES (see diagram below).
NOTE! The engine must have the system switched
on when you change the display settings or calibrate
functions.
Configuration menu structure
System
information
Language (8 available)
Click sound
ON, OFF
Engine PORT, STARBOARD
TWIN, SINGLE
Engine series D1/D2, >D2
Settings GLOBAL, LOCAL
Display
Units
Calibration
Depth offset
Speed
Settings
System
Engine [2500 rpm: 9000 rpm] in stages of 500 rpm
Speed On, off
Speed [10 KNOT: 100 KNOT] in stages of 10 (in appropriate units)
Graph interval 2MIN, 10MIN, 30MIN, 60MIN, 2 H, 4 H, 8 H
Demo
Com Viewer
Prog. tx
About
Read more about this display mode
in the section after the diagram.
Speed Knots, mph, km/hr
Distance NM, Miles, km
Oil pressure kPa, psi
Turbo pressure kPa, psi
Fuel consumption Liter/hr, Gal(US)/hr, IGal/hr
Temperature degrees C, degrees F
Volume Liter, Gal(US), Imperial Gallons
Depth (std distance) m, ft
Menu SYSTEM is for
service technicians
Menu UNITS is only
available if LOCAL
is selected in menu
SETTINGS
Przeglądanie stron 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 75 76

Komentarze do niniejszej Instrukcji

Brak uwag