Volvo Car navigation system Instrukcja Użytkownika Strona 1

XC90SectionGroupWeight(Kg/Pounds)YearMonth3391 (2.2)200712XC90 2003, XC90 2003, XC90 2003, XC90 2003, XC90 2003, XC90 2004, XC90 2004, XC90 2004, XC90

17IMG-280114Preparations● Drill up the three holes for the cradle's feet using a Ø14 mm (9/16") step drill.18IMG-280115Preparations● Take th

20BIMG-28011821AIMG-280119 21BIMG-280120 21CIMG-280121 InstallationIllustration A applies to cars up to and including model year -05 Illustration B ap

22IMG-277338 Installation● Take the cable harness and foam tape out of the kit. Remove the protective tape.23IMG-280122 Installation● Wrap the foam ta

26IMG-280125 InstallationApplies to cars up to and including model year 05●Remove the loudspeaker grille and loudspeaker from the kit. Secure the loud

29IMG-280129 Installation● Take the loudspeaker and cradle. Connect the connector on the small cable to the cradle.30IMG-280130 Installation● Insert t

33IMG-239204Installation34IMG-279903Installation35IMG-242267Installation●Turn the ignition key to position II.● Reconnect the battery negative lead.In

Required toolsA0000162IMG-282403IMG-240675IMG-246925IMG-239660IMG-239667IMG-240673IMG-239681IMG-280472IMG-280106Installation instructions, accessories

IMG-213320Installation instructions, accessories - Navigation system portable Volvo Car Corporation Göteborg, SwedenInstallation instructions, accesso

INTRODUCTION● NOTE! Read through the entire text before carrying out any work.● The front page gives the date of this edition and the edition it repl

1IMG-282404Assembling the holder●Take special tool 9814104 (torx driver, torx 6), and unscrew the two screws holding the connector in the holder.● Car

5AIMG-282406 5BIMG-282409 Assembling the holderIllustration A● Install the spacer in the bottom of the holder.Illustration B● Ensure that the holder&a

8IMG-246024 Preparations●Turn the ignition key to position 0.● Disconnect the battery negative lead.Note!Wait at least three minutes before unplugging

11BIMG-280133 Illustration B● Lay out a cloth to protect the tunnel console and unit. Place as illustrated. Depending on the design the cable may need

15AIMG-28011015BIMG-280111PreparationsIllustration A● Remove the loudspeaker grille as follows: Insert the special tool, 9995919 into the joint betwee